To connect the 1046 to your system, refer to the following steps:
• Turn off all equipment before making any connections.
• Mount the 1046 in a rack
Install the 1046 in a rack with the rack screws provided. It can be mounted above or below
anything that does not generate excessive heat. Ambient temperatures should not exceed
113˚ F (45˚ C) when equipment is in use. Although the unit is shielded against radio frequency
and electromagnetic interference, extremely high fields of RF and EMI should be avoided.
• Make audio connections via XLR, 1/4”TRS, or 1/4”TS plugs.
Both types of connectors for the inputs and outputs can be used for balanced or unbalanced
connections. The use of more than one connector at a time for the input/output pair could
unbalance balanced lines, cause phase cancellations, short a conductor to ground, or cause
damage to other equipment connected to the 1046.
• Apply power to the 1046
Connect the AC power cord to the AC power receptacle on the back of the unit. Route the AC
power cord to a convenient power outlet away from audio lines. The unit may be turned on and
off via the rear panel power switch or from a master equipment power switch.
Front Panel
Gain Reduction Meter - This 8 stage meter shows the amount of gain reduction due to both
compression and/or Intelligent Predictive Limiting™, displaying gain reduction from 0 to 30 dB.
Compressor Threshold Control - This control sets the level above which compression occurs, and has
a 60 dB range.
OverEasy® Switch - OverEasy® provides a smooth transition from the compressor’s linear region to
Connecting the 1046 to your system
Commentaires sur ces manuels