Dbx DriveRack PA2 Manuel du propriétaire télécharger pdf (Page 10)

Rear Panel

120V 50/60Hz

2 3

1. IEC AC Power Inlet

Connect the included IEC power cord to this power inlet. The DriveRack PA2 ships from the factory configured for one

of two specified power voltage ranges, they are:

• 100-120V, 50Hz/60Hz

• 220-240V, 50Hz/60Hz

NOTE: Ensure the screening under this outlet matches the voltage specification in your country before applying

power to the PA2.

2. Ethernet Port

This RJ45 connector is used for updating the firmware and controlling the PA2 from a networked device using the free

DriveRack PA2 control app. See ‘Network Connections’ on page 9 and ‘Networking’ on page 57 for more

information.

NOTE: A DHCP enabled switch or Wi-Fi router is required to assign an IP address to the PA2 for network

control.

3. USB Port

This USB connector is used for updating the PA2’s firmware. See ‘Firmware Updates’ on page 59 for more

information.

4. Outputs 1-6

These six electronically balanced XLR outputs correspond to the low, mid, and high processing modules in the

PA2’s output processing section. Crossover frequency points can be extended to overlap each other in the crossover

processing module, allowing multiple outputs to be configured for full range operation if required.

5. Inputs 1-2

Connect your mixer to these electronically balanced XLR connectors. These inputs can be configured for stereo or mono

applications in the Wizard. The input sensitivity of these jacks are affected by the +4dBu/-10dBV switch.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 69 70

Pas de commentaire

Dbx DriveRack PA2 Manuel du propriétaire Page 10