Dbx DriveRack PA2 Manuel du propriétaire télécharger pdf (Page 51)

Power-Up Functions

Power-up functions allow you to reset DriveRack PA2 presets and settings, lock out the front panel controls, and configure

the PA2 to always power up with the output mutes enabled. These power-up functions are accessed by pressing and holding

certain buttons upon power-up. The following section describes the power-up functions available in the PA2 and how to use

them.

Initialize With Mutes On

This power-up function forces the PA2 to boot up with all outputs initially muted. This will prevent audio from passing through

the PA2’s outputs until you’re ready to manually unmute the output channels.

To initialize the PA2 with mutes on:

1� Press and hold any output MUTE button then power on the PA2. Keep the button pressed until the LCD display reads,

“MUTE BUTTON HELD All outputs will be muted after initialization.” then release the MUTE button.

2� The PA2 will now initialize with all outputs muted regardless of the mutes’ previous state when the PA2 was last powered

down.

NOTE: The INITIALIZE WITH MUTES ON option is a one-time operation. After performing this power-up function, the

PA2 will revert back to normal operation – meaning the PA2 will power up with all mutes set to the state they were at when

the processor was last powered down. The exception is if you have enabled the MUTES POWERUP option in the Utility

menu, in which case the PA2 will always power up with all output mutes enabled. See ‘Utility’ on page 46 for further

information on this feature.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 69 70

Pas de commentaire

Dbx DriveRack PA2 Manuel du propriétaire Page 51