Dbx DriveRack PA2 Manuel du propriétaire télécharger pdf (Page 55)

Full Range Application 2 (Sub-Satellite System)

The full range application may also be used for some 2-way powered sub-satellite speaker systems, where you have a pair of

powered mains and one or two powered subwoofers which are part of the same product series and are meant to be integrated

together. These type of integrated powered speaker systems are designed by the manufacturer to be easy to setup and use.

If you have such a system and PA2 tunings are available for your powered main and sub speakers, it is recommended that

you configure the PA2 for a 2-way system. See ‘2-Way Application’ on page 53 for further information on this type

of application. If the PA2 does not contain tunings for your speakers and you are unable to download them from the online

database using the DriveRack PA2 control app, it is recommended that you configure the system as shown in the following

system diagram.

In this type of configuration, the PA2 will send full range signal (20 Hz - 20 kHz) through the HIGH outputs. The powered

subwoofer(s) would then perform the job of the crossover (separating the mid/high frequencies from the low frequencies). You

can still utilize most of the features in the PA2, with the exception of the crossover, and in some cases the limiters – as some

of these speaker systems may have built-in limiters which cannot be defeated. When the PA2 is configured for this type of

application using the Setup Wizard, only the HIGH outputs will be enabled; the MID and LOW outputs will be disabled and will

not pass audio.

Application Notes:

• Make sure your mixer and powered speakers are turned off before making connections.

• Make connections as described in ‘Making Connections’ on page 8 then apply power to the system according to

the instructions described in ‘Applying Power’ on page 10.

• Run the Setup Wizard and select the MONO input option if connecting your mixer to the PA2 via a single connection, or

select the STEREO input option if connecting the mixer to the PA2 via a left/right stereo connection.

• In the Setup Wizard, select the NOT LISTED option from the tuning list. If prompted, select the PASSIVE option for your

main speaker configuration and NO for subs.

120V 50/60Hz

Left Main

Powered Speaker

Mono

Powered Subwoofer

Right Main

Powered Speaker

To Power

Outlet

Windows

or Mac

Computer

iOS

or Android

Tablet

iOS

or Android

Phone

Mixer

R L/Mono

Wireless Router

LEGEND

Analog Audio Connections

Omit Connection For Mono Systems

Ethernet Connection

IEC Power Cord

Left Channel

Right Channel

Wi-Fi Signal

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 69 70

Commentaires sur ces manuels

Pas de commentaire

Dbx DriveRack PA2 Manuel du propriétaire Page 55

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement musical Dbx DriveRack PA2